Видео

Where at?

This video was really helpful. Thank you!

Yeah but at the end of the day that’s-1 kart hit

Pro tip: use gloves when putting in the new bulbs, oil from skin can cause "hot spots" on the new bulbs and burn out faster. Great video.

Thank you.

5 qt? Only takes 4.5 or less.

Quick question, would that be the same for a ford Taurus sel 2011 bank 1 sensor 2 o2 replacement?

Simple and direct, you made it seem so easy to do appreciate your video. I'm sure will help Many people in the future

This is awesome. I just bought one of these and I am going to do the oil change today. Thanks from Vermont.

Does ls have this

Hey G hiw did you get your side splitters on i bought thise and the screws it came with dont wanna go the the rubber texture underneath

Is it safe to replace the compressor and then drive the car to a shop for the vacuum and charge?? Without turning on the AC while driving there of course

I have the same question as @mattanderson1890 . I need to replace the compressor, but what additional items SHOULD be replaced while undertaking this project? Do I need to replace any other components?

I thought the engine was warming up and only at 104 - then you mention it's 104 OUTSIDE. Thanks for this video - it's my project today!

Thank you 😊

To pull the axle - Hang the axle more or less horizontally by tightening a rope around the outer end of the axle and securing it to the spring. Wrap another rope around the inner axle case (between the inner axle case and the gearbox), creating a simple self-tightening loop. Extend the other end of the rope outward along the axle and attach a regular hammer to it. Make a couple of hits in the outward direction along the axle. The hammer's momentum applied along the rope (along the axle) will pull the axle from the gearbox easily. I just tried it, and it works well. It's better to use a non-scratching rope, such as Dyneema.

Is this the same for 1995 mustang gt??

no offense, but the check engine light isn't likely going to come on 10 seconds after your repair lol. I fixed mine after trying the plug first and it took 30 minutes with the vehicle on before CEL came back on. Otherwise, great quick video showing how to install the part itself and it's definitely one of the more common causes for P0303

Bro hearing your Honda whine makes my day 😅sounds awesome bro sounds like its definitely getting me from the line 😆

I was looking for something else but was fascinated by hiw brine is made. Thank you sir!

But they will SELL YOU A FILTER 😡

If your not going to over 450whp, fx300/350 will suffice. They last longer than the puck style. Just my experience with them

This may be an old video but it was exactly what I needed. Took me 5 minutes total. The repair shop quoted me $350 and it cost me only $15 to replace. Thanks again!

I'm confused. What's the point as the stock intake already is basically a 'CAI' from factory, sucking air from the fender.. 😢 The stock resonator not only provides sound, but it is tuned to provide torque throughout the powerband. Honda spent close to a Million $ designing the intake alone, last minute, before production started in 2006 for the revised, Fg2 coupe. Fa5 production started in 2007. Even HFP (Honda Factory Performance) didn't change the stock airbox for gains Left it as-is for a reason. HPF offered suspension, 18" wheels and an axle back muffler. Pretty sure Honda knew what they were doing 😊

Thank you! That's not easy to do with two hands, let alone one! The light-colored granules around the post are exactly the opposite of laundry detergent-dry sulfuric acid, among other things. They result from corrosion of the lead battery terminal. If you're careful, you can wash them off with water. Some people use baking soda and water, but if the solution gets into the battery cells, it can neutralize the acid inside the battery.

hope this will work for my 07, same problem, have display, no sound

Just found out my 2012 si needs a new compressor and condensor. Labor is very pricy, so me and a mechanic friend might tackle the job...i just have a few questions If we get a new condensor and compressor on, will i be able to drive it to a shop to have the lines vaccum sealed and cleaned out, and re filled with fre on?

Hi! Good video. I just bought a used 2016 Malibu. Does it matter if the battery doesn’t have the metal encasement and metal plate on top of it?

🔥🔥🔥

Thank you good video

I’m looking to install this radio in my dodge journey but mine is a 2020 and I have a camera already. Would I still have to run a camera? I ask bc my back up camera pops up on my rear view mirror. Any help cars just not my thing but I’m trying to learn lol

Saved my life fasho

I had the same issue on my Honda Civic 2015 sedan, Warning lights for ABS, TPMS, Power Steering and Hill. I had a open circuit / cutted wire on my front-right ABS wheel sensor detected first by a OBD scanner to find the clue easy. This same solution was applied and now all warning disapeared!

Thanks a ton man this helped me a lot!

OMG FIRST! Keep the content coming

That supercharger tho 😅🔥🔥

Thanks for posting because I looked at how tight the battery was in the Lincoln vs other cars I have. Now I have a little more confidence in trying to change out the battery. Your video simplified everything.

I didn’t even know they made radiators lol

Miss the guys and these drives more than anything

I have an fk8. After you reset the ecu to stock, do you have to buy the jailbreak again for $250?

Thank you sir! 😀

What if there’s alr a 20 amp in there ?

Hello, I want to change that part on my Honda, it's the same. I would like to know what size the die is to remove the oxygen sensor.

I have a question for you sir if you can please tell me is this the same way to put in a 2017 Ford edge is this the same way to put it in

Hello, great video, What was the cause for replacing the catalytic converter?

Nice job, come do mine😂 Where did you buy the Y pipe and cats? Dealer?

After the process did you drain the coolant to get the blue devil sealant out and add new coolant?

Will the Honda civic Si injectors work on the non Si-1.5L turbo also?

Just like so 🤯

OH NO! You didn't remove the screen. That's very often the problem because it gets plugged up.